Full implementation planned 2012 Italy None Luxembourg None If used outside of own premises, general authorization is required General authorization required for network and service supply(not for spectrum) Norway Implemented This subsection does not apply for the geographical area within a radius of 20 km from the centre of Ny-lesund Russian Federation None Only for indoor applications Note: Please dont use the product outdoors in France.
Refarming of the 2.4 GHz band has been ongoing in recent years to allow current relaxed regulation. within the band 2454-2483.5 MHz Military Radiolocation use. National Restrictions This device is intended for home and office use in all EU countries (and other countries following the EU directive 1999/5/EC) without any limitation except for the countries mentioned below:Ĭountry Restriction Reason/remark Bulgaria None General authorization required for outdoor use and public service France Outdoor use limited to 10 mW e.i.r.p. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. This device is restricted to indoor use only CE Mark Warning This is a class B product. SAR measurements are based on a 10mm spacing from the body and that compliance is achieved at that distance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. End users must follow the specific operating instructions for satisfying RF exposure compliance. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Such modifications could void the users authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. 2 This device must accept any interference received, including interference that may cause undesired operation. Operation is subject to the following two conditions:ġ This device may not cause harmful interference. This device complies with part 15 of the FCC Rules. Consult the dealer or an experienced radio/ TV technician for help. Connect the equipment into an outlet on a circuit different from that to which the Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Copyright 2014 TP-LINK TECHNOLOGIES CO., LTD. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders.
Please try to find out the driver from there.Archer T4UH AC1200 High Gain Wireless Dual Band USB Adapter REV1.0.0 1910011097 COPYRIGHT & TRADEMARKS is a registered trademark of Specifications are subject to change without notice. Include/linux/fs.h:2572:14: note: previous declaration of ‘file_path’ was hereĮxtern char *file_path(struct file *, char *, int) Ĭontacted TP-Link who passed the buck and said that "the chip set for Archer T4UH is Realtek RTL8812AU. In file included from include/linux/compat.h:15:0,įrom /home/a/Driver/include/osdep_service_linux.h:35,įrom /home/a/Driver/include/osdep_service.h:41,įrom /home/a/Driver/include/drv_types.h:32, home/a/Driver/include/hal_com.h:412:13: error: ‘file_path’ redeclared as different kind of symbol Running 'make' reports - In file included from /home/a/Driver/include/drv_types.h:95:0, The 'driver' available on your website for the TP-Link AC1200 Model T4UH (Version V1.0) is version 150821 and is for System version: Ubuntu 14.04.1